CAB DISPLAY MODULE (CDM)
4.3.2 Calibra
ting the Header Tilt Sensor
NOTE:
• The header MUST be at tached t o the windrower to pe rf orm this procedure. The cab displa y module (CDM)
automatically adjusts its programming for each header.
• This procedure require s installation of the optiona l Hydrau lic Cen te r-L ink (MD #B 46 50) an d optional A uxiliary
Valve (MD #B5269).
• Displaying center-link position on cab display module (CDM) requires installation of the optional Expansion
Module (MD #B4666). For m ore information, refer to the windrower operator’s manual or the windrower
technical manual.
• The engine MUST be running to perform this procedure.
147962 176 Revision A
To Next Page
Loading...
