MacDon M Series - Calibrating the Header Sensors; Calibrating the Header Height Sensor

CAB DISPLAY MODULE (CDM)
4.3 Calibrating the Header S ensors
Sensor calibration programs the windrower control module (WCM) with settings for the attached header.
4.3.1 Calibrating the Header Height Sensor
NOTE:
• The header MUST be at tached t o the windrower to pe rf orm this procedure. The cab displa y module (CDM)
automatically adjusts its programming for each header.
• The engine MUST be running to perform this procedure.
147962
17
2
Revision A