CAB DISPLAY MODULE (CDM)
CAUTION
Check to be sure all bystanders have cleared the area.
7. Press SELECT (E) until RE EL DRV SPD XXXX is
displayed on the upper line.
IMPORTAN T:
Do NOT over-speed the reel.
8. Press and hold HAZARD (C) button.
• Press left (B) arrow to decrease reel speed.
• Press right (D) arrow to increase reel speed.
Verify the reel drive is functioning properly.
9. Release the HAZARD (C) button. The reel will stop.
Figure 4.364: M155 Reel Drive
Figure 4.365: M205 Reel Drive
10. Press
PROGRAM (A) to exit Programming Mode or
press
SELECT (E) to proceed to next ACTIVATE
FUNC
TION.
4.8.12 Testing the Rotary Disc Drive Circuit Activate Function Using the
Cab Display Module (CDM)
IMPORTAN
T:
Do not ove
r-speed a drive. Over-speeding can lead to vibration, belt failures, or other over-speeding related
problems
.
NOTE:
• A rotary disc header MU ST be attached to windrower to follow this procedure.
• The engine MUST be running to perform this procedure.
147962 309 Revision A
To Next Page
Loading...
