CAB DISPLAY MODULE (CDM)
4.4.11 Settin
g the Header Cut Width
NOTE:
• The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
• Header cut width is less than actual header width to accurately measure number of acres cut.
• The headers sends an electrical signal to the windrower to produce a header ID; however, the cut width will
always default to the smallest header size available for each header type. For example, A-Series Auger Headers
come in 14-, 16-, and 18-foot sizes, but the cut width will automatically default to the smallest 14-foot size and
will need to be changed to your specific header’s size.
147962 201 Revision A
To Next Page
Loading...
