ASSEMBLING THE W INDROWER
3.18 Installing AM/FM Radio
Windrowers are designed to accept a DIN E style
AM/FM radio with a depth (X) of 161 mm and having
a 5 mm threaded stud (A) centered on the rear for
support. Adjustments are possible if the radio falls outside
these parameters.
In order to retain radio settings and preset memory with
the battery disconnect turned off, select a radio with
non-volatile settings mem ory.
NOTE:
An approved radio package is available from Radio
Engineering Industries (REI) of Omaha, Nebraska.
NOTE:
Configuration for the M105 differs slightly from what is
shown, but the installation procedure is the same.
Figure 3.137: Mounting Dimension
1. Ensure the ignit
ion is turned to the OFF position.
2. Remove radio pan
el by removing four screws (A).
Figure 3.138: Radio Panel
3. Remove screw a
nd nuts (A) and (C) to remove
support (B) f
rom panel. Retain nut(C) and lock washer.
Figure 3.139: Panel Support
147962 90 Revision A
To Next Page
Loading...
