MacDon M Series - Page 9

Summary of Change
Location
Added new cros
s-reference and section for fluids,
lubricants, a
nd system capacities.
• 3.22 Lubricating the Windrower, page 150
• 5.2 Checking and Adding Wheel Drive Lubricant
Level, page 321
• 6.4 Lubricants, Fluids, and System Capacities, page
374
Revised Not
e regarding cab display module and
windrower c
ontrol module software to clarify software
version com
patibility with different M-Serie s windrow er
models.
4.2 Cab Display Options, page 156
Revised Notes specific to the M105 for clarity.
• 4.4.9 Setting the Header Index Mode, page 196
• 4.7.3 Displaying Header Sensor Input Signals, page
260
Corrected references in Steps 7 and 8 from callouts C
and D to callouts A and B.
• 4.8.3 Tes
ting the Header Tilt Activate Function Using
the Cab D
isplay Module (CDM), page 278
• 4.8.7 Te
sting the R eel Fore -Aft Act ivate Fu nction
Using the
Cab Display Module (CDM), page 288
Replaced arrows showing serial number locations with
callouts.
5.1 Recording Serial Numbers, page 319
Updated illustration to show new g e arbo x cove r.
5.8 Ch
ecking Gearbox Lubricant Level on an
M155/
M205, page 330
Corrected broken links to Table 5.5 Knife Speed
Setting, page 352.
• Setting Knife Speed, page 352
• Adjusting Knife Speed, page 353
Replaced M105 Operator Console illustration to show
header drive switch.
5.11.8 Checking Operator's Presence System, page
341
Add
ed new section for tapered pipe fittin gs.
6.1.8 Tapered Pipe Thread Fittings, page 369
Added new terms and acronyms.
6.3 Definitions, page 371
Added new section for fuel specifications. 6.5 Fuel Specifications, page 378
147962
vi
i
Revision A