ASSEMBLING THE W INDROWER
11. Engage safety props on both lift cylinders as follows:
a. Stop engine and remove key from ignition.
b. Pull lever (A) and rotate towards the header
to release and lower safety prop (B) onto the
lift cylinder.
c. Repeat for opposite lift cylinder.
Figure 3.
194: Safety Prop
12. Install pin (B) through the header leg (engaging
U-bracket in lift linkage) on both sides and secure with
hairpin ( A).
13. Raise header stan d (D) to storage po sition by pulling
spring pin (C) and lifting stand into uppermost position.
Release spring pin.
Figur
e 3.195: Header Leg
147962
11
2
Revision A
To Next Page
Loading...
