CAB DISPLAY MODULE (CDM)
1. Turn ignition ke y to RUN, or start the e ngine. Refer to
3.15 St artin g Engine , pag e 84.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrowto select YE S. PressSELE CT (C).
• SET K NIFE SPEED? is displayed on the upper line.
• SELECT HEADER TYPE? is displayed on the
upper line.
Figure 4.7
4: M105 CDM Programming Buttons
Figure
4.75: M155 CDM Programming Buttons
147962 186 Revision A
To Next Page
Loading...
