CAB DISPLAY MODULE (CDM)
6. Press SELECT ( D) until H EA DER TILT is displayed on
the upper line.
• ENABLED/L O C KED is displayed on the lower line.
7. Press left (B) arrow to enable HEADER TILT
control switch.
Press right (C) arrow to lock HE ADER TILT
control switch.
8. Press PROGRAM (A) to exit Programming Mode, or
press SELECT (D) to p roceed to next WINDROWER
SETUP action.
Figure 4.2
18: M105 Header Tilt Control Lock
Figure
4.219: M155 Header Tilt Control Lock
Figure 4.220: M205 Header Tilt Control Lock
147962 248 Revision A
To Next Page
Loading...
