Maxim Integrated MAX32660 - Page 35

MAX32660 User Guide
Maxim Integrated Page 35 of 195
Reset 0 Register
GCR_RST0
[0x0004]
Bits
Name
Access
Reset
Description
29
soft
R/W1O
0
Soft Reset
Write 1 to perform a soft reset. A soft reset resets all peripherals including the GPIO port pin
configuration but does not reset the Watchdog Timer peripheral.
0: Reset complete.
1: Write 1 to perform the soft reset.
Refer to the Device Resets section for additional information.
28:18
-
RO
-
Reserved for Future Use
Do not modify this field.
17
rtc
R/W1O
0
RTC Reset
Write 1 to reset the peripheral state to the reset default state. When complete this field will
read 0.
0: RTC peripheral not in reset.
1: Write 1 to reset the RTC peripheral.
16
i2c0
R/W1O
0
I2C0 Reset
Write 1 to reset the peripheral state to the reset default state. When complete this field will
read 0.
0: I2C0 peripheral not in reset.
1: Write 1 to reset the I2C0 peripheral.
15
-
RO
0
Reserved for Future Use
Do not modify this field.
14
spi1
R/W1O
0
SPIMSS (SPI1/I
2
S) Reset
Write 1 to reset the peripheral state to the reset default state. When complete this field will
read 0.
0: SPIMSS (SPI1/I
2
S) peripheral not in reset.
1: Write 1 to reset the SPIMSS (SPI1/I
2
S) peripheral.
13
spi0
R/W1O
0
SPI0 Reset
Write 1 to reset the peripheral state to the reset default state. When complete this field will
read 0.
0: SPI0 peripheral not in reset.
1: Write 1 to reset the SPI0 peripheral.
12
uart1
R/W1O
0
UART1 Reset
Write 1 to reset the peripheral. This field is cleared by hardware when the peripheral is
reset.
0: Reset complete.
1: Write 1 to reset the UART1 peripheral.
11
uart0
R/W1O
0
UART0 Reset
Write 1 to reset the peripheral state to the reset default state. When complete this field will
read 0.
0: UART0 peripheral not in reset.
1: Write 1 to reset the UART0 peripheral.
10:8
-
RO
0
Reserved for Future Use
Do not modify this field.
7
timer2
R/W1O
0
Timer2 Reset
Write 1 to reset the peripheral state to the reset default state. When complete this field will
read 0.
0: TMR2 peripheral not in reset.
1: Write 1 to reset the TMR2 peripheral.