11.5 Sample Processor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
94
￭￭￭￭￭￭￭￭
900 Touch Control
NOTICE
In the case of a Sample Processor with 2 towers, Tower 1 is the tower
on the right and Tower 2 is the tower on the left, when viewed from
the front.
Maximum stroke path
Lowest permissible lift position for automatic and manual operation.
This is a safety setting. A correct specification of this value can prevent the
glass of an electrode from breaking, because a titration head can not be
moved below the position specified.
Input range 1 to 235 mm
Default value 235 mm
Min. beaker radius
Smallest permissible radius of the sample vessels for automatic and man-
ual operation.
This is a safety setting. It is intended to prevent a completely loaded, wide
titration head from being moved into a narrow sample vessel.
Input range 1.0 to 100.0 mm (Increment: 0.1)
If the lift is to be moved to the work position, a
check is made to see whether the beaker radius
defined for the attached rack (see "Beaker radius
samples", page 102) is less than this value.
Selection off
Default value off
off
No check takes place.
To Next Page
Loading...
