11.4 Metrohm control instruments
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
88
￭￭￭￭￭￭￭￭
900 Touch Control
Remote Box). If the control instrument is not connected, then the proper-
ties dialog of the control instrument will be displayed directly (see chapter
11.4.1, page 88).
[Properties]
Open the properties dialog of the highlighted entry.
The following properties can be displayed and edited to a certain extent:
￭ Properties of the control instrument (see chapter 11.4.1, page 88)
￭ Properties of the measuring inputs (see chapter 11.4.2, page 88)
This dialog is available only for devices which have a built-in measuring
input.
￭ Properties of the MSB connectors (see chapter 11.4.3, page 90)
￭ Properties of the peripheral devices on the MSB connector (see chapter
11.4.4, page 91)
11.4.1 Properties – Control instrument
Instrument list: Control instrument ▶ Edit ▶ Properties
Device name
This designation is used for identification purposes when selecting control
devices (command, manual control).
Entry 24 characters maximum
Comment
Entry 24 characters maximum
Program version
Program version of the instrument software.
Serial number
Shows the serial number of the device.
11.4.2 Properties – Measuring input
Instrument list: Control instrument ▶ Edit ▶ Measuring input
1/2 ▶ Properties
To Next Page
Loading...