29.13 Calculations
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
430
￭￭￭￭￭￭￭￭
900 Touch Control
29.13.3.3 Variable list
The following table contains all of the variables which can be used for cal-
culations. For variables having an index (e.g. 'EP1'), the index must be
entered manually. In the following table, this index is characterized with
the character "#".
Variable Description
C00 Sample size
CI1, CI2 Sample identifications
The sample identifications can be used in calculations only if numerical values are entered.
DD Duration of the entire determination
Titrants
TITER Titer of the titrant selected in the titration command
CONC Concentration of the titrant selected in the titration command
Titrations, measurements, calibrations
EP# Volume/quantity of endpoint EP# (# = 1 - 9)
EC# Charge at endpoint EP# (# = 1 - 9)
EM# Measured value of endpoint EP# (# = 1 - 9)
EF# ERC of endpoint EP# (# = 1 - 9)
ET# Temperature at endpoint EP# (# = 1 - 9)
ED# Time at endpoint EP# (# = 1 - 9)
ESI# Recognition of endpoint EP# (# = 1 - 9)
Endpoint found = 1, no endpoint = 0
MIM Initial measured value, i.e. measured value prior to the processing of the start conditions
MIT Initial temperature, i.e. temperature prior to the processing of the start conditions
MSA Volume for start volume
MSP Volume for start measured value
MSS Volume for start slope
MSV Volume for all the start conditions
MSD Duration of start conditions
MSM Start measured value, i.e. measured value after the processing of the start conditions
MST Start temperature, i.e. temperature after the processing of the start conditions
MCD Total duration of the titration, measurement or calibration
MTM Type of temperature measurement (Pt1000, NTC or manually)
Format = Text
MDD Duration of effective dosing, i.e. without filling times, pauses
To Next Page
