Profiles & Options
The dialog contains some sample profiles; you can change these profiles or add
new ones by clicking on Add new profile at the bottom of the dialog.
The Profile field contains the name of the profile. Remember to enter a descriptive
name as this name is later displayed in other dialogs.
• Phone Number or SIP Address: Enter the Phone Number or SIP Address,
which the camera should call in case of an alarm. Set the remaining
parameters as required (Dial Attempts and Dial Timeout). Click on the Add
button to add phone numbers or SIP addresses to this profile.
• Connection type: Sets the connection type for this phone profile. The profile
can use either
ISDN
or
SIP
connections (Internet telephony). Make sure that
the camera has been configured accordingly and that the connections have
been set up (e.g. in Admin Menu > VoIP Settings).
• Message name: Select one of the voice messages available in Admin
Menu > Manage Voice Messages. The camera will play back this message
when it places the call.
• Confirm call with PIN code: If desired, enter a PIN code, which has to be
entered by the recipient of the call (using the touchtone keys of the phone) in
order to acknowledge the alert.
• After the message has been sent: Select one of the audio modes
Speak
,
Hangup
,
Listen
or
Intercom
, if the corresponding devices have been acti-
vated in the Admin Menu > Loudspeaker and Microphone dialog. The
camera will execute the selected option after it has played back the voice
message.
• Camera Remote Control: Set this option to
On
if you would like to allow
remote-controlling the camera using touchtone phone keys. It is only avail-
able if After the message has been sent has been set to
Speak
,
Listen
or
Intercom
.
• Hangup after: Set the maximum duration of a phone call using this
parameter. It is only available if After the message has been sent has been
set to
Speak
,
Listen
or
Intercom
.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com • 10.10.2006
184/288
Software Camera Manual Part 2
Set a PIN code to make
sure that the call is prop-
erly acknowledged
Camera remote control
using a phone
Note
If the camera can establish the phone connection, but no PIN (or an
invalid one) is being entered (e.g. an unauthorized recipient or an
answering machine), the camera will close the connection after a cer-
tain time and will call the next number of the phone profile.
To Next Page
Loading...
