In the Scheduled Access Control dialog, set the access rights for all user groups in
the Global Rules section. The Group Rules section allows setting individual options
for the individual user groups (test-user in the test-users group in our example).
The settings of the Global Rules section take priority over the settings of individual
group rules as set in the Group Rules section. If you would like to use the group
rules, select the Allow access as set in Individual Group Rules below option in the
Group Rules section.
You can set the following options to restrict camera access:
• Deny access:
This user group never has access.
• Allow access:
This user group always has access.
• Allow scheduled access from ... to ...:
Use this option if you would like to set the start and end times of the period
during which access is granted for this group. Note that the start time can
also be in the past. The end time has to be at least three minutes in the
future, but may not be in the future for more than a year (365 days). Enter the
times as Year-Month-Day-Hour:Minute.
The from now for … allows setting a duration in
minutes
,
hours
or
days
dur-
ing which access is granted. The time starts counting as soon as you click
Set
; the end time is computed from the duration you entered.
• Allow access as set in Individual Group Rules below:
Activate this option if you would like to configure the scheduled access indi-
vidually for specific groups. Set the scheduled access for each user group
listed in the Group Rules section.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com • 10.10.2006
91/288
Software Camera Manual Part 2
Global rules are valid for
all user groups, group
rules only for the
corresponding user group
Caution
Make sure you store the Supervisor password in a safe place if you
change it—if you forget the password, there will be no possibility to
get into the Supervisor area any more. Not even a member of the
admins group can deactivate the Supervisor feature without knowing
the Supervisor password. If the admins user group has been blocked
from accessing the camera, the camera has to be sent back to
MOBOTIX. Resetting the camera to the factory default settings is only
possible at MOBOTIX or one of its subsidiaries (this service is not free!).
To Next Page
Loading...
