– 79 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
AP/FP CARD TYPE, HIGHWAY CHANNEL
05
INITIAL
Y
AP/FP/
VIRTUAL AP
NUMBER
SETTING DATA
RELATED
COMMAND
REMARKS
DATA MEANING
8
NOTE 1: When the Remote site number 01-30 is set, the system recognizes that the as FP/AP is accommodated
at Remote site.
NOTE 2: The PIM number is a serial number within each site.
NOTE 3: When CM05 Y=4 is set, FP/AP is set as the FP/AP accommodated in the PIM at Main site.
NOTE 4: When setting the station number assigned by CM10/14 to the Physical PIM/Virtual PIM, the setting
data of CM05 Y=8 cannot be changed.
When changing the data of CM05 Y=8, clear the station number that is assigned to the Physical PIM/
Virtual PIM.
NOTE 5: You should set one PIM to the FP number of Virtual FP. If two PIMs are set to the FP number of Virtual
FP, the Virtual FP cannot operate normally.
04-15, 20-31 XX ZZ Setup of Virtual PIM which accommodates
Virtual AP
XX: 00: Site Number (When the system is
main site of Remote PIM over IP)
ZZ: 12/13: Virtual PIM number
[Series 3200 R6.2 (R6.2)]
CM50 Y=0 NOTE 11
9 00-63
See
PRECAUTION
(2)
000
064
NONE
Number of Virtual Station Ports used by visi-
tor station in visitor site
Number of Virtual Station Ports for Visitor
No data
[Series 3500]
CM14 NOTE 16
Continued on next page
FP/AP No. FP/AP KIND
ACCOMMODATED SITE
(SITE No.)
PIM
(PIM No.)
00 FP Main Site (00) PIM0/PIM1 (0001)
01 FP Main Site (00) PIM2/PIM3 (0203)
02 FP Main Site (00) PIM4/PIM5 (0405)
03 FP Main Site (00) PIM6/PIM7 (0607)
04-31 FP Not used Not used
04-31 AP Main Site (00) No data (99)
~
DECEMBER/02/2005
CM05
To Next Page
Loading...
