– 80 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
AP/FP CARD TYPE, HIGHWAY CHANNEL
05
NOTE 1: CM05 Y=2 is effective only for FP/DAIA/DAID card and MP built-in FP.
CM05 Y=4 is effective only for FP/DAIA/DAID card, MP built-in FP and Virtual FP.
Available FP numbers for each FP/DAIA/DAID card are as follows:
PN-CP15/PN-CP17: FP No. 01-03
PN-DAIA-A/PN-DAID-A: FP No. 01-03, 16-19
NOTE 2: FP No. 00 is used for MP built-in FP.
NOTE 3: Assign LT Highway number to each FP number as follows:
FP No. 00/16: LT Highway number 0
FP No. 01/17: LT Highway number 1
FP No. 02/18: LT Highway number 2
FP No. 03/19: LT Highway number 3
NOTE 4: When no Remote PIM is provided, do not set this data.
NOTE 5: When the Remote PIM over IP feature is not provided for the system, this data setting is not
required.
NOTE 6: Set this data to the FP number of FP card/MP built-in FP. Do not set this data to the AP/FP
number of Virtual FP/AP.
NOTE 7: Be sure to set every 8 port. If the setting value of the second data cannot be divided by 8, the
value of the remainder is omitted and not assigned to the FP number.
NOTE 8: Assign the Virtual PIM No. to each FP number as follows.
FP No. 00: NONE
FP No. 01: Virtual PIM No. 02
FP No. 02: Virtual PIM No. 04
FP No. 03: Virtual PIM No. 06
FP No. 16: Virtual PIM No. 01
FP No. 17: Virtual PIM No. 03
FP No. 18: Virtual PIM No. 05
FP No. 19: Virtual PIM No. 07
NOTE 9: When the FP number 16-19 are used, you must assign the PIM number 0-7 to the FP number
00-03.
For example;
(1) 00: FP No. 00
(2) 00: Controls PIM0
(1) 16: FP No. 16
(2) 04: Controls PIM4
Continued on next page
INITIAL
JULY/01/2006
CM05
To Next Page
Loading...
