– 81 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
AP/FP CARD TYPE, HIGHWAY CHANNEL
05
NOTE 10: We recommend the setting of the PIM number of Virtual PIM controlled by the FP number
by CM05 Y=8, when using Series 3200 R6.2 (R6.2) software or later.
NOTE 11: When setting the Virtual IPT to Virtual PIM, Virtual PIM number 12 must be set first.
After setting Virtual PIM number 12, set the number 13, if required.
NOTE 12: Do not set the second data to “1” (accommodated in Remote Site), when the Remote PIM
over IP feature is not provided for the system.
NOTE 13: When accommodating the AP number in a Remote Site, set CM05 Y=6 to 1.
NOTE 14: CM05 Y=4/8 cannot be changed when the station number has been already assigned by
CM10/CM14.
When you change CM05 Y=4/8, clear the station number set by CM10/CM14 before chang-
ing.
NOTE 15: Be sure to set the number of port every 8 port.
If the setting value of second data cannot be divided by 8, the value that the remainder is
omitted that has been assigned to the FP number.
NOTE 16: The port number can be used from the port number 000 up to the value set by this command.
For example, when setting the number of ports to 64 by this command, the port number can
be used from 000 to 063.
NOTE 17: When setting this command for NEAX IPS
DM
/NEAX IPS
DMR
, the number of ports should be
assigned in consideration of the port number for the virtual LEN as shown below.
For example, when using the physical LEN up to 00087, the number of port should be as-
signed as 088.
Physical LEN Virtual LEN
(for LT slot)
MC2: 01000-01039 01040-01063
MC1: 00064-00103 00104-00128
MC0: 00000-00039 00040-00063
LEN: XXYYY
XX : 00/01 (FP No.)
YYY: 000-128 (Port No.)
INITIAL
JANUARY/20/2006
CM05
To Next Page
Loading...
