– 98 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
156 Dialing of a Single Digit Feature Access Code while the calling
station hears RBT, or performs a Voice Call
0
1
Available
Not available
The table below shows the available features and its access codes for Single Digit Feature Access Code, while
the calling station hears RBT.
NOTE 1: While the D
term
or DP telephone is holding the other call, this feature is not available.
NOTE 2: While the DTMF telephone is holding the other call, this feature is not available.
157 Whether the Paging Answer code and the Paging Access code
are to be the same or not.
If codes are the same, paging access codes must be set to trunk
routes (in CM30 Y=00), as follows:
Paging Answer Zone 0: Trunk Route 50
9: Trunk Route 59
CM20>A070-A079, are used to set the combined access/
answer codes.
0
1
Same
Different
See CM20>A070-A079
CM30 Y=28
CM44>02XX
NOTE: The second data must be set to 0 when one Paging trunk is connected with the multiple AMP relay cir-
cuits or one Paging trunk is connected with two AMP relay circuits simultaneously.
158 All Zone Internal Paging
See CM56 Y=00-05 CM20>A164
0
1
Not available
Available
Continued on next page
Access
Code
Service
Feature
Calling Station Kind
Attendant
Console
D
term
DP
Telephone
DTMF Telephone
1 Voice Call Available Available Available Available after Hooking
NOTE 2
2 Call Back-Don’t
Answer
Not
Available
Available
NOTE 1
Available
NOTE 1
Available after Hooking
NOTE 2
6 Message Reminder/
Message Waiting Set
Available Available Available Available after Hooking
NOTE 2
8 Message Waiting
Record
Available Available Available Available after Hooking
NOTE 2
~
~
JUNE/01/2007
CM08
To Next Page
Loading...
