– 99 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
161 Transfer a trunk line placed in Consultation Hold
(Hold Transfer)
0
1
Available (Hold Transfer)
Not available (Consultation Hold)
162 Multiple Radio Paging access after accessing a Radio Paging
trunk with delay type Radio Paging
NOTE: This is ineffective when CM08>157: 0.
0
1
Not available
Available
163 Step Call for an incoming call from a Tie Line 0
1
Not available
Available
165 Replay timer for Attendant Delay Announcement 0
1
Replay at an interval
See CM41 Y=0>47
Replay only once
168 When the DTMF station or D
term
station dials “#” during set-
ting of Speed Calling-Station (Station Speed Dialing)
0
1
“#” is set as paused data (1.5 seconds)
“#” is set as dialed digit
171 When the DTMF station or D
term
station dials “*” during set-
ting of Speed Calling-Station (Station Speed Dialing)
0
1
“*” is set as programmable pause by
CM41 Y=0>38
“*” is set as dialed digit
172 Automatic Idle Return on D
term
0
1
Not available
Available
176 1000-Slot Memory Block number “2” for Speed Calling-Sta-
tion (Station Speed Dialing) is used as the Memory Block for
Speed Calling-System (System Speed Dialing)
0
1
Available See CM20>A068
Not available
177 Last Number Call (Last Number Redial) 0
1
Available See CM20>A069
Not available
178 Last Number Call (Last Number Redial) /Stack Dial for internal
calls
NOTE: Effective only when CM08>177: 0.
0
1
Not available (Only available for
external calls)
Available
179 Ringing cadence on Direct in Termination
[Other than North America]
0
1
As per CM35 Y=33
Special Ringing
See CM08>397
Ringing cadence on Direct in Termination
[North America Only]
0
1
As per CM35 Y=33
0.4 seconds ON-0.2 seconds OFF
-0.4 seconds ON-2 seconds OFF
Continued on next page
JUNE/01/2007
CM08
To Next Page
Loading...
