– 102 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
208 Dialing of a Single Digit Feature Access Code, while the calling
station hears busy tone
0
1
Available
Not available
To activate Single Digit Feature Access Code, set CM08>050, 051, 069 and 148 to “1”.
The table below shows the available features and its access codes for Single Digit Feature Access Code, while
the calling station hears busy tone.
Continued on next page
050 If the * button on a DTMF telephone is pressed while hearing busy tone, it is
regarded as a Switch Hook Flash
1Ineffective
051 If the # button on a DTMF telephone is pressed while hearing busy tone, it is
regarded as a Switch Hook Flash
1Ineffective
069 When a station user has dialed any one digit while hearing busy tone 1 Step Call
148 When a station user, upon encountering the called station busy, has dialed
the same last digit again hearing busy tone
1Ineffective
NOTE 1: While the D
term
or DP telephone is holding the other call, this feature is not available.
NOTE 2: While the DTMF telephone is holding the other call, this feature is not available.
Access
Code
Service
Feature
Calling Station Kind
Attendant
Console
D
term
DP
Telephone
DTMF
Telephone
2 Call Back/Outgoing Trunk Queueing
(Trunk Queuing-Outgoing)
Not
available
Available
NOTE 1
Available
NOTE 1
Available
NOTE 2
3 Executive Right of Way
(Executive Override)
Not
available
Available
NOTE 1
Available
NOTE 1
Available
NOTE 2
4 Station Camp-On
(Camp-ON)
Available Available Available Available
NOTE 2
5 Call Waiting Available Available Available Available
NOTE 2
6 Message Reminder/Message Waiting
Set
Available Available Available Available
NOTE 2
7Step Call
(7 + Last one digit)
Available Available Available Available
NOTE 2
8 Message Waiting Record Available Available Available Available
NOTE 2
CM08
To Next Page
Loading...
