NEC UNIVERGE NEAX 2000 IPS - Page 166

– 142 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
LAN INTERFACE ASSIGNMENT
0A
IPT INITIAL
IP-PAD INITIAL
SIP INITIAL
: Initial Data
Y 1ST DATA 2ND DATA
No. MEANING DATA MEANING DATA MEANING
10 TCP/UDP/RTP Port of
LAN Interface 00 for SIP/
IP-PAD
90
92
93
94
UDP Port for
Voice control
TCP Base Port
for H.245 con-
trol
RTP Base Port
for Voice Packet
transmitting/
receiving
UDP Port for
SIP control
packet
[Series 3600]
01024
65534
NONE
TCP/UDP/RTP Port number
1st data=90: 50000
(Port number 50000
is used)
1st data=92: 6000
(Port number 6000-
7024 are used)
1st data=93: 10000
(Port number 9998-
10317 are used)
1st data=94: 05060
(Port number 05060
is used)
NOTE 1: 10 ports from the TCP/
UDP/RTP Port num-
ber are used per LAN
Interface.
NOTE 2: Set this data when the
router or firewall pro-
vides the restriction by
the TCP port.
NOTE 3: The same port number
cannot be used for the
port number which
UDP Port for Voice
control (1st data=90),
TCP Port for H.245
control (1st data=92)
and RTP Port for
Voice Packet transmit-
ting/receiving (1st
data=93).
11 TCP/UDP/RTP Port of
LAN Interface 01 for SIP/
IP-PAD
12 TCP/UDP/RTP Port of
LAN Interface 02 for SIP/
IP-PAD
13 TCP/UDP/RTP Port of
LAN Interface 03 for SIP/
IP-PAD
14 TCP/UDP/RTP Port of
LAN Interface 04 for SIP/
IP-PAD
15 TCP/UDP/RTP Port of
LAN Interface 05 for SIP/
IP-PAD
16 TCP/UDP/RTP Port of
LAN Interface 06 for SIP/
IP-PAD
17 TCP/UDP/RTP Port of
LAN Interface 07 for SIP/
IP-PAD
Continued on next page
~
DECEMBER/02/2005
CM0A