NEC UNIVERGE NEAX 2000 IPS - Page 197

– 173 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
LAN DATA ASSIGNMENT
0B
Y=10
INITIAL
: Initial Data
Y 1ST DATA 2ND DATA
No. MEANING DATA MEANING DATA MEANING
10 UDP Base Port number of
the PROTIMS port (NEC
original UDP port)
[Series 3200 R6.2
(R6.2)]
00-31 Virtual FP num-
ber
01024
65535
NONE
UDP Base Port number
See below
FP No.
UDP Port No.
00 50000
01 50064
02 50128
03 50192
..
..
..
..
31 51984
NOTE 1: Set the UDP Base Port number by CM0B Y=11, when using Series 3300 software or later.
NOTE 2: 64 ports from the UDP Base Port number you set are assigned to Virtual FP number. If no data is set,
the UDP port number is assigned to No. 50000-51984.
NOTE 3: One port from the UDP Base Port number you set is assigned to the Virtual FP number automatically,
when the second data of CM05 Y=6 is set to “1” (accommodated in remote site).
NOTE 4: A UDP port is required to a D
term
IP. Assign the necessary number of UDP port to Virtual FP number
suitable for the number of D
term
IPs.
NOTE 5: Since the UDP port number 0-1023 is reserved for specific applications (Well-Known port), the UDP
port number 0-1023 cannot be used.
UDP port number of Regis-
tration Admission Status
(RAS) port
(NEC original UDP port for
System-based DRS)
60 RAS port 00000
01023
01024
65534
NONE
UDP port number 3456
UDP port number 1024
UDP port number 65534
UDP port number 3456
Continued on next page
~ ~~
~
NOVEMBER/15/2006
CM0B