– 187 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
UPDATING OF D
term
IP FIRMWARE/MP PROGRAM DOWNLOAD
(FTP)
0C
: Initial Data
Y 1ST DATA 2ND DATA
No. MEANING DATA MEANING DATA MEANING
51 Downloading MP
program for MP Pro-
gram Download
(FTP) (Main Site)
[Series 3500]
00 Execute MP pro-
gram download
0
1
3
YYYY MM
DD HH mm
CCC
Start to download
Now downloading
Not executed
Download time
YYYY: Year (2000-2099)
MM : Month (01-12)
DD : Date (01-31)
HH : Hour (00-23)
mm : Minutes (00-59)
Interrupt downloading/Download
time clear
NOTE 1: You can download the MP programs while the system is operating. The down-
loaded program is stored in flash memory of MP card.
NOTE 2: The second data 0 can be set only when the MP program download is not exe-
cuted (second data status is 3) and the system data backup is not being executed.
NOTE 3: The second data XXXXXXXXXXXX (download time) can be set only when the
MP program download is not executed (second data status is 3) and the system
data backup is not being executed.
NOTE 4: While the MP program is being downloaded (second data status 0), you can in-
put CCC to interrupt the program download.
If you do that, the second data is changed from 1 (Now downloading) to 3 (Not
executed), and the MP program that has been downloaded disappears.
Execute the MP program download again, if required.
NOTE 5: While the MP program is being downloaded, you cannot input any command
other than CCC. If you do that, “WAIT, BUSY NOW” is displayed.
NOTE 6: The download time can be canceled by inputting CCC when the second data
XXXXXXXXXXXX (download time) is displayed.
NOTE 7: Execute the changeover of MP program, after the MP program download is
completed.
Continued on next page
JULY/01/2006
CM0C
To Next Page
Loading...
