NEC UNIVERGE NEAX 2000 IPS - Page 241

– 217 – NWA-008844-001 Rev.5.0
91ch3002.fm
COMMAND CODE
TITLE:
STATION CLASS-1
12
: Initial Data
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
07 Service Restriction Class C 00
15
Service Restriction Class C (00-15)
NOTE: The features available in each Class are
programmed in CM15.
CM15
11 Kind of idle status of called
station on DID MFC call
0
1
2
3
Called station idle (No Charge)
Called station control (Charge)
Called station idle (Charge)
Called station idle (Charge)
12 Calling Party Number
displayed on called side
X
XXXXXXXX
NONE
ISDN/SIP subscriber number (ISDN/SIP Indial
No.)/Station number (ANI/Enhanced-911)
No data
CM12 Y=46
NOTE 1: As the second data, assign the Indial number informed when a call is originated from the station.
For a station for which no Indial number is informed, assign NONE.
NOTE 2: When the system accommodates both ISDN and SIP trunks, the subscriber number assigned by this com-
mand is used for ISDN. Assign a subscriber number with CM12 Y=46 for SIP.
13 ISDN/SIP Local Office
Code Table
00
14
15
ISDN/SIP Local Office Code Table number 00
ISDN/SIP Local Office Code Table number 14
No data
CM12 Y=47
CM50 Y=05
NOTE 1: When the system accommodates both ISDN and SIP trunks, the Local Office Code Table assigned by
this command is used for ISDN. Assign a Local Office Code Table with CM12 Y=47 for SIP.
16 Trunk to be seized as
Private Line on per station
basis
D000
D255
NONE
Trunk number
No data
CM35 Y=18
CM42>09
CM35 Y=28
CM15 Y=25
NOTE: When assigning Private Line on a per station basis, Outgoing Trunk Queuing (Trunk
Queuing- Outgoing) and Timed Queue features are not available.
To restrict Outgoing Trunk Queuing, set the second data “0” by CM35 Y=28. Also to
restrict Timed Queue, set the second data “0” by CM15 Y=25.
Continued on next page
~ ~ ~
~
~
NOVEMBER/15/2006
CM12