– 238 – NWA-008844-001 Rev.5.0
91ch3002.fm
COMMAND CODE
TITLE:
STATION NUMBER, TRUNK NUMBER, CARD NUMBER FOR EACH FP
14
(2) LEN is determined by setup of CM05 Y=0/4/6/8, refer to “LEN ASSIGNMENT” about location
of LEN at the initial setting. Page A2
(3) When deleting a station number (Single Line or D
term
), be sure to delete Call Pickup data (CM16),
ACD/UCD Group data (CM17) and Station Hunting Group data (CM18) in advance.
(4) When assigning Conference Trunk (ED00-ED03), a system reset is required after data setting.
(5) After assigning the data for PN-8RST (DTMF receiver), PN-2CSI/PN-4CSI (CSI), PN-2ILCA
(ISDN Terminal), you must unplug the circuit cards, then plug them again (After unplugging the
circuit card, you must wait for 30 seconds before plugging the circuit card again.).
(6) 5 or more digits station number should not be assigned when the following features with AP00 are
used.
•SMDR/PMS
• Front Desk Terminal/D
term
TIMS (CIS)
(7) Remote Site cannot accommodate the following FP/AP/LT cards.
8RSTA/G (PBR) NOTE
NOTE: Four-line built-in PBR on the MP card is available at Remote Site.
When Remote Site is IPS
DMR
/IPS
DM
, in addition to the above conditions, the following
LT cards are restricted.
PN-4LDTA (LDT), PN-4LLCB (LLC), PN-8PFTB (PFT)
NOVEMBER/15/2006
CM14
To Next Page
Loading...
