NEC UNIVERGE NEAX 2000 IPS - Page 374

– 350 – NWA-008844-001 Rev.5.0
91ch3003.fm
COMMAND CODE
TITLE:
TRUNK ROUTE DATA
35
: Initial Data
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
15 Kind of call termination
indicator key/lamp on Atten-
dant Console
Call termination indicator
lamps further categorized by
the kind of calls (ex.C.O
incoming call or Tie line
incoming call).
00
07
10
17
20
27
30
37
40
47
75
NONE
C.O. Incoming Call 0 (Standard “LDN” key)
C.O. Incoming Call 7
FX Incoming Call 0 (Standard “FX” key)
[North America Only]
FX Incoming Call 7
WATS Incoming Call 0
(Standard “WATS” key)
[North America Only]
WATS Incoming Call 7
CCSA Incoming Call 0
(Standard “CCSA” key)
[North America Only]
CCSA Incoming Call 7
Tie Line Incoming Call 0
(Standard “TIE” key)
Tie Line Incoming Call 7
Call Termination via No. 7 CCIS
No data
CM46
CM90
CM50
NOTE 1: When the standard lamp indications are utilized, set the standard data.
NOTE 2: Set the correspondence between the key positions on Attendant Console and this assignment data by
CM46 or CM90.
16 Sending of Hook Flash to
outside
0
1
Not sending
Sending
CM90 Y=00:
F1009
CM41 Y=2>17
Continued on next page
~~ ~ ~ ~ ~~~~
~
NOVEMBER/15/2006
CM35