– 355 – NWA-008844-001 Rev.5.0
91ch3003.fm
COMMAND CODE
TITLE:
TRUNK ROUTE DATA
35
: Initial Data
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
39 Trunk release by detecting
reversal of tip and ring on
outgoing C.O. call
0
1
Not released
To release
40 Abbreviated Codes for speed
calling for routing to C.O.
line when all tie lines are
busy
00
31
Abbreviated Codes for Speed Calling-System
(System Speed Dialing) assigned by CM71>66
CM71>66
CM72
41 Line Fault Detection
[Australia Only]
0
7
To detect
Not detected
42 Metering
[Australia Only]
0
7
Metering
No Metering signal (C.O./Tie line)
43 Both way path connection
between PB station and PB
trunk when providing sender
prepause
00
15
To connect
Not connected
NOTE: Maximum number digit analysis
should be provided to prevent one way
calls.
CM08>193, 194,
331
CM35 Y=76
CM85
CM8A Y=4000-
4007
44 Trunk access code sent to
SMDR for outgoing call/
Trunk Access Code for
Trunk-Direct Appearance
Multiline Operation
000
or
999
NONE
When a trunk is seized by a Trunk
Appearance key or LCR, one or two-digit code
(00-99) is sent out to the SMDR.
No data
CM35 Y=189
CMD000>60
NOTE: When both CM35 Y=44 and CM35 Y=189 are set to the same trunk route, the setting of CM35 Y=189
is effective.
45 DP sender release timing 0
1
2
3
4
5
6
7
2 seconds
4 seconds
6 seconds
8 seconds
12 seconds
14 seconds
16 seconds
10 seconds
Continued on next page
~
~
~
NOVEMBER/15/2006
CM35
To Next Page
Loading...
