EasyManua.ls Logo

NEC UNIVERGE NEAX 2000 IPS - Page 378

NEC UNIVERGE NEAX 2000 IPS
1038 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
– 354 – NWA-008844-001 Rev.5.0
91ch3003.fm
COMMAND CODE
TITLE:
TRUNK ROUTE DATA
35
: Initial Data
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
33 Interval of ringing signal to
station on incoming calls
[North America Only]
0
1
2
3
0.4 seconds ON-0.2 seconds OFF-0.4 seconds
ON-2 seconds OFF
0.4 seconds ON-0.2 seconds OFF-0.4 seconds
ON-2 seconds OFF
1 second ON-2 seconds OFF
2 seconds ON-4 seconds OFF
NOTE: For incoming calls to Trunk Line Appearance key on D
term
, the special ringing; 0.2 seconds ON-0.2
seconds OFF will be applied.
34 D
term
Ringer Tone Pattern
on incoming calls
[Series 3200 R6.1 (R6.1)]
0
1
2
3
See below CM08>390
CM15 Y=83, 84
CM65 Y=40
D
term
ringer tone pattern is assigned by the following combination of CM35 Y=34 and 164.
36 Trunk seizure facility 0
1
After dialing maximum number of digits
After completing dialed digits entered in CM8A
Y=4005-4007
CM8A
Y=4005-4007
37 MF/MFC Signaling on DID 0
1
Available
Not available
38 MFC Signaling on DOD/
Enhanced 911
0
1
Available
Not available
Continued on next page
: Initial Data
NOTE: For the Ringer Tone Pattern, see CM65 Y=40.
Y=34 Y=164: 0 Y=164: 1
0 Ringer Tone Pattern 3 Ringer Tone Pattern 0
1 Ringer Tone Pattern 6 Ringer Tone Pattern 1
2 Ringer Tone Pattern 5 Ringer Tone Pattern 2
3 Ringer Tone Pattern 4 Ringer Tone Pattern 7
CM35

Table of Contents

Other manuals for NEC UNIVERGE NEAX 2000 IPS

Related product manuals