– 372 – NWA-008844-001 Rev.5.0
91ch3003.fm
COMMAND CODE
TITLE:
TRUNK ROUTE DATA
35
: Initial Data
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
233 Release of ISDN trunk when
receiving the ISDN DIS-
CONNECT message with
Progress Description=08
from ISDN because the
called party is busy in tan-
dem connection (ISDN to
ISDN)
[Series 3600]
0
1
To release
Not released
CM35 Y=266
NOTE 1: To release the ISDN trunk when receiving the ISDN DISCONNECT message, set the second data 0 to
the incoming trunk route of tandem office.
NOTE 2: Assign the second data 0 to the incoming and forwarding trunk route of Mobility Access.
234 Type of number/Numbering
plan identification of ISDN
Calling Party Number
[Series 3500]
0
1
To provide
Not provided
CM35 Y=230, 231
244 Dial Tone (DT) sending to
calling party of opposite
office when receiving the
SETUP message by Overlap
Receiving-Q-SIG
[Russia Only]
[Series 3600]
0
1
To send DT of own office
Not sent
NOTE 1: This command can be also used to specify whether the SETUP message does not contain a called par-
ty number is enabled or not.
When the SETUP message does not contain a called party number message is not enabled, assign the
second data to “0”.
NOTE 2: This command should be assigned to incoming trunk route when sending DT to calling party.
NOTE 3: This command should be assigned to both incoming trunk route and outgoing trunk route when the
SETUP message does not contain a called party number is not enabled.
Continued on next page
JANUARY/20/2006
CM35
To Next Page
Loading...
