NEC UNIVERGE NEAX 2000 IPS - Page 397

– 373 – NWA-008844-001 Rev.5.0
91ch3003.fm
COMMAND CODE
TITLE:
TRUNK ROUTE DATA
35
: Initial Data
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
245 Calling Party number (1-8
digits) transfer to ISDN on
tandem call from Q-SIG
[Series 3400]
0
1
To provide
Not provided
247 Forced release in designated
time for outgoing trunk route
[Series 3500]
0
1
To provide
Not provided
248 Forced release in designated
time for incoming trunk
route
[Series 3500]
0
1
To provide
Not provided
249 Warning SST sending timer
for forced release to the
incoming trunk route of tan-
dem connection
[Series 3500]
0
1
2
3
Depends on Timer A (CM41 Y=0>114)
Depends on Timer B (CM41 Y=0>115)
Depends on Timer C (CM41 Y=0>116)
Forced release is not provided
CM35 Y=247
CM41 Y=0>114
CM41 Y=0>115
CM41 Y=0>116
NOTE: This command is effective when the forced release is provided to the outgoing trunk route of tandem
connection (CM35 Y=247 is set to 0).
250 Extended Interdigit Pause
Timer for outgoing call
[Series 3500]
0
1
To provide
Not provided
CM41 Y=0>117
254 Whether the call terminat-
ing method is specified for
incoming call with no CLI in
Day Mode
[Series 3600]
0
1
3
Specified when reason of the incoming call with
no CLI is “Privacy”
Specified for all incoming call with no CLI
Not specified
CM35 Y=255
NOTE: Assign the call terminating method by CM35 Y=255 when this command is set to 0/1.
255 Specification of the call ter-
minating method for incom-
ing call with no CLI in Day
Mode
[Series 3600]
0
1
2
3
To transfer to the DAT/another station/
Attendant Console (assigned by CM51 Y=33)
To reject the call termination
To terminate the D
term
with unusual LED
indication (assigned by CM35 Y=258)
To terminate as usual
CM35 Y=254, 258
CM51 Y=33
Continued on next page
JANUARY/20/2006
CM35