NEC UNIVERGE NEAX 2000 IPS - Page 398

– 374 – NWA-008844-001 Rev.5.0
91ch3003.fm
COMMAND CODE
TITLE:
TRUNK ROUTE DATA
35
: Initial Data
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
256 Whether the call terminat-
ing method is specified for
incoming call with no CLI in
Night Mode/Mode A/
Mode B
[Series 3600]
0
1
3
Specified when reason of the incoming call with
no CLI is “Privacy”
Specified for all incoming call with no CLI
Not specified
CM35 Y=257
NOTE: Assign the call terminating method by CM35 Y=257 when this command is set to 0/1.
257 Specification of the call ter-
minating method for incom-
ing call with no CLI in Night
Mode/Mode A/Mode B
[Series 3600]
0
1
2
3
To transfer to the DAT/another station/Atten-
dant Console (assigned by CM51 Y=33)
To reject the call termination
To terminate the D
term
with unusual LED indi-
cation (assigned by CM35 Y=258)
To terminate as usual
CM35 Y=256, 258
CM51 Y=33
258 Distinctive LED indication
on D
term
for incoming call
with no CLI
[Series 3600]
0
1
Green (120 IPM)
Red (120 IPM)
CM35
Y=32, 255, 257
NOTE: This command is effective on the following conditions.
• CM35 Y=32 is set to 1.
• CM35 Y=255, 257 are set to 0 or 2, and D
term
receives the incoming call.
265 Screening Indicator (ISDN
Calling party number)
[Series 3500]
3
NONE
Network provided
No data
266 Relay of the ALERT mes-
sage to the calling party in
tandem connection (ISDN to
ISDN)
[Series 3600]
0
1
To provide
Not provided
CM35 Y=233
NOTE 1: This command should be set to both incoming trunk route and outgoing trunk route of tandem office.
NOTE 2: To send tone to the calling party according to the status of calling party (idle or busy) as shown below,
set the second data of CM35 Y=233 and CM35 Y=266 to “0”.
• RBT is sent when the calling party is idle.
• BT is sent when the calling party is busy.
NOTE 3: Set the second data 0 to the incoming and forwarding trunk route of Mobility Access.
Continued on next page
JANUARY/20/2006
CM35