– 377 – NWA-008844-001 Rev.5.0
91ch3003.fm
COMMAND CODE
TITLE:
TRUNK ROUTE DATA
35
: Initial Data
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
279 Pattern number for adding
an access code for outgoing
call to the calling number
stored by Message Reminder
when terminating a tandem
call via CCIS
[Series 3800]
0
7
NONE
Pattern No. 0
Pattern No. 7
No data
CM50 Y=11
281 Calling party number relay-
ing in ISDN to ISDN/CCIS
to ISDN connection (for
incoming trunk route)
[For EU]
[Series 3800]
0
3
To provide
Not provided
CM35 Y=282
NOTE 1: This command must be set for incoming trunk route.
NOTE 2: Calling party number relaying in ISDN tandem connection is available when both CM35 Y=281 and
CM35 Y=282 are set to 0.
282 Calling party number relay-
ing in ISDN to ISDN/CCIS
to ISDN connection (for out-
going trunk route)
[For EU]
[Series 3800]
0
3
To provide
Not provided
CM35 Y=281
NOTE 1: This command must be set for outgoing trunk route.
NOTE 2: Calling party number relaying in ISDN tandem connection is available when both CM35 Y=281 and
CM35 Y=282 are set to 0.
283 TEI (Terminal Endpoint
Identifier) assignment for
ISDN terminals
[Series 3800]
0
1
Automatic TEI assignment (TEI=64-126)
Non-Automatic TEI assignment (TEI=0)
CM35 Y=79
NOTE: Automatic TEI assignment (second data 0) is effective only when CM35 Y=79 is set to 1 (Point-to-
Multipoint).
Continued on next page
~
~
BRT INITIAL
NOVEMBER/15/2006
CM35
To Next Page
Loading...
