NEC UNIVERGE NEAX 2000 IPS - Page 432

– 408 – NWA-008844-001 Rev.5.0
91ch3004.fm
COMMAND CODE
TITLE:
SYSTEM TIMER DATA
41
Y
1ST
DATA
MEANING
INITIAL
DATA
2ND DATA
INCREMENT
UNIT
TIMER
3
15
Metering Signal Detect
timing on DTI trunk
[Australia/Argen-
tina]
160
ms.
01 02 ................. 05.......................................... 15
32 ms.
32 64 ................ 160........................................ 480
16
No-Answer detect tim-
ing on 32-Party Con-
ference
30
seconds
00 01 02...........................................14 15
1 minute
(01-14)
NOTE 2 1 2............................................14 30
seconds
NOTE 1: Ringing is stopped when the participant does not an-
swer within the time set by this data.
NOTE 2: If the 2nd data is set to “00”, the ringing will continue
until the participant answers.
17
Forced release timer
for 8/32-Party Confer-
ence
7
hours
00 01 02...........................................23 24
1 hour
NOTE 2 1 2............................................23 24
NOTE 1: This command is effective only when PN-CFTC-A card
is used.
NOTE 2: If the 2nd data is set to “00”, the Forced Release Timer
doesn’t work.
NOVEMBER/15/2006
CM41