– 505 – NWA-008844-001 Rev.5.0
91ch3005.fm
COMMAND CODE
TITLE:
LOCATION DATA ASSIGNMENT
67
: Initial Data
Y 1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING DATA MEANING DATA MEANING
00 NOTE 3: Specify the CODEC type and the payload size for the location number of group which D
term
SP20/
D
term
SP30/MH210/MH220/MH250 belongs. Set the CODEC list that the CODEC type and the pay-
load size are set as shown in the table below (D
term
SP20/D
term
SP30/MH210/MH220/MH250 does not
support the CODEC type G.723.1).
Do not set the different CODEC list to the location groups that the voice packet is sent/received.
NOTE 4: The setting of small payload size is effective for the voice quality measures in general, but the used
bandwidth become bigger. Set the payload size considering the available bandwidth in the network.
01 Type of Service
(TOS) field Prece-
dence for D
term
IP/
Virtual IPT/IP-
PAD between loca-
tion group
[Series 3200
R6.2 (R6.2)]
XX ZZ XX: Location
number of
group (00-63)
ZZ : Location
number of
group (00-63)
X Z
NONE
CCC
X: PRECEDENCE 0-7
for control packet
Z : PRECEDENCE 0-7
for voice packet
65
Clear
CM12 Y=39/50
CM8A Y=5000-
5255: 173
CM0A Y=09/29
CMAD Y=29
NOTE 1: This data setting is valid to the packets that are sent to the group which is set to “ZZ” in the first data
from the group which is set to “XX” in the first data.
NOTE 2: The priority of PRECEDENCE 0-7 is as follows.
PRECEDENCE 0: Lowest priority
PRECEDENCE 7: Highest priority
PRECEDENCE 6 for control packet and PRECEDENCE 5 for voice packet are recommended.
NOTE 3: By CM67 Y=01 setting, the router recognizes the precedence of control packet and voice packet and
controls Weighted Fair Queuing (WFQ).
NOTE 4: When this data is set, DSCP set by CM67 Y=06 becomes invalid.
Continued on next page
Terminal CODEC TYPE
PAYLOAD SIZE
(MILLISECONDS)
REMARKS
D
term
SP20 G.711 40 Fixed to 40 ms.
G.729a 40
D
term
SP30 G.711 20/30/40 10 ms. is not available
G.729a 20/30/40
MH210/MH220/
MH250
G.711 20/30/40
G.729a 20/30/40
~
NOVEMBER/15/2006
CM67
To Next Page
Loading...
