NEC UNIVERGE NEAX 2000 IPS - Page 536

– 512 – NWA-008844-001 Rev.5.0
91ch3005.fm
COMMAND CODE
TITLE:
LOCATION DATA ASSIGNMENT
67
: Initial Data
Y 1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING DATA MEANING DATA MEANING
14 Type of Service
(TOS) field Prece-
dence of control
packet for D
term
IP/
IP-CS/Virtual CS/
ZT for WLAN-to-
system for each
location group
00
63
Location number 0
1
2
3
4
5
6
7
NONE
CCC
PRECEDENCE 0
PRECEDENCE 1
PRECEDENCE 2
PRECEDENCE 3
PRECEDENCE 4
PRECEDENCE 5
PRECEDENCE 6
PRECEDENCE 7
PRECEDENCE 6
Clear
CM12 Y=39/50
CMAD Y=29
NOTE: The DSCP that is set by CM67 Y=15 is invalid when this data is set.
15 Diffserv Code
Point (DSCP) of
control packet for
D
term
IP/IP-CS/
Virtual CS/ZT for
WLAN to each
location number
[Series 3200
R6.2 (R6.2)]
00
63
Location number 00
FF
NONE
DSCP of control packet
C0
CM12 Y=39/50
CMAD Y=29
NOTE: The TOS field precedence that is set by CM67 Y=14 is invalid when this data is set.
16 Minimum value of
jitter buffer for
each location
group
00
63
Location number 01
30
NONE
CCC
10 ms.
300 ms.
(10 ms. increments)
10 ms.
Clear
CM12 Y=39
CM8A Y=5000-
5255: 173
CM0A Y=09
NOTE 1: Assign the value which does not exceed the maximum value of jitter buffer set by CM67 Y=17.
NOTE 2: When using Series 3200 R6.2 (R6.2) software or later, set the minimum value of jitter buffer by CM67
Y=04.
Continued on next page
~ ~
~
~ ~ ~
CM67