CHAPTER 2 PRECAUTION
– 30 – NWA-008844-001 Rev.5.0
91ch2001.fm
Conditions for Using Commands
NOTE: SIP initial is required only when SIP Trunk Source IP Address Check is provided by CM0A
Y=79: 0.
CONDITION COMMANDS MEANINGS
Commands which require a
reset of the SIP card after
data setting.
• Set the Make Busy switch
to UP and then DOWN.
CM0A LAN Interface Assignment
CMBA Y=04, Y=10,
Y=13, Y=14, Y=21, Y=30,
Y=31, Y=137 NOTE
H.323/SIP Profile Data
Commands which require a
reset of the IP-PAD card
after data setting.
• Set the Make Busy switch
to UP and then DOWN.
CM0A LAN Interface Assignment
SIP INITIAL
IP-PAD INITIAL
NOVEMBER/15/2006
CONDITIONS FOR USING COMMANDS
To Next Page
Loading...
