CHAPTER 2 PRECAUTION
– 29 – NWA-008844-001 Rev.5.0
91ch2001.fm
Conditions for Using Commands
CONDITION COMMANDS MEANINGS
Commands which can be
used only under Off-Line
mode of the AP00 card. See
“METHOD OF SETTING
ON-LINE/OFF-LINE
MODE”. Page 32
CMD100 Billing System Data Partial Clear for PN-
AP00-B with AP00 Program
CMD101 Billing System Data All Clear for PN-AP00-
B with AP00 Program
CMD102 Billing Memory Clear for PN-AP00-B with
AP00 Program
CMDD98 Billing Memory Clear for PN-AP00-B/PN-
AP00-D with MRCA Program
CMDD99 Billing System Data All Clear for PN-AP00-
B/PN-AP00-D with MRCA Program
Commands which require a
reset of the CFTC card after
data setting.
• Set the Make Busy switch
to UP and then DOWN.
CMAA Y=10 Conference trunk partition for CFTC
Commands which require a
reset of the IPT card after
data setting.
• Set the Make Busy switch
to UP and then DOWN.
CM0A LAN Interface Assignment
CMA7 Y=46 Connection method for IP trunks
CMA7 Y=52-62 IP Trunk Data
CMBA Y=04, Y=10,
Y=12-19, Y=21, Y=22,
Y=30-32, Y=34, Y=36-39,
Y=41, Y=42, Y=45-51
H.323/SIP Profile Data
Continued on next page
AP OFF LINE
CFT INITIAL
IPT INITIAL
JULY/01/2006
CONDITIONS FOR USING COMMANDS
To Next Page
Loading...
