NEC UNIVERGE NEAX 2000 IPS - Page 733

– 709 – NWA-008844-001 Rev.5.0
91ch3008.fm
COMMAND CODE
TITLE:
OAI CONTROL DATA
D7
NOTE 1: OAI Function key number is assigned by CM90.
NOTE 2: The digit code is assigned by CMD7 Y=6.
NOTE 3: The maximum number of operation codes is 16.
NOTE 4: Digit number is assigned by CMD7 Y=0.
NOTE 5: Do not use * as a digit code.
NOTE 6: The maximum number of operation codes is 128.
NOTE 7: Setting data for CMD7 Y=A>01 is effective only when CMD7 Y=A>00: 1.
: Initial Data
Y 1ST DATA 2ND DATA
No. MEANING DATA MEANING DATA MEANING
7 Chime from D
term
when
receiving RR signal of
MSF/TMF
F1032
F1047
OAI Function Key No. 0
OAI Function Key No. 15
00
01
Not sent
To send
8 Chime from D
term
when
setting up TMF
00 Chime before sending terminal
messages (when pressing OAI
Function Key)
00
01
Not ring
Ring
02 Chime after sending terminal
messages
Display of guidance on
D
term
when setting up
TMF
01 Display of guidance before
sending terminal messages
(when pressing OAI Function
Key)
00
01
Not displayed
To display
03 Display of guidance after send-
ing terminal messages
A AP database of FLF
[Series 3300]
00 Recognition of AP database by
RR message
0
1
To provide
Not provided
01 Omission of AP database for
information added to RR mes-
sage NOTE 7
0
1
Not omitted
To omit
Chime from D
term
when
MSF is canceled
11 When Terminal Mode is can-
celed
0
1
Ring
Not ring
Chime from D
term
at the
time terminal mode is
released
[Series 3100]
0B Chime sending out at the time
(MRFR, MRFI) terminal mode
release
0
1
Not ring
Ring
~ ~
JULY/01/2006
CMD7