Running Mail
57
3
Running Permit Mail
After completing the initial set up in
Steps to Set Up Permit Mail Printing
p.55, follow
the steps below to run mail.
Steps to Run Permit Mail
Steps to Run
Permit Mail
From the Print Mode:[
Permit mail
] home screen:
1 Start a new Operational Permit Report if necessary.
Press Reset/Report to open the Operational Permit Report
screen and start a new report.
You can also print the current report before starting the new
one.
For details, see
Operational Permit Report and Historic
Reports
p.148.
2 Select the sealing mode that corresponds to your mail stack:
see
Checking the Sealing Mode p.42.
3 Depending on the weighing mode selected, run mail ac-
cording to one of the sections below:
Steps to Run Mail in Dynamic Weighing Modes
p.44
Running Mail in Standard Weighing Mode
p.45
Running Mail in Manual Weigh Modes
p.49.
When sealer is activated, collect the mail piece stack in the catch
tray and put stack aside to let envelopes dry.
OMEGA1_US.book Page 57 Vendredi, 1. octobre 2010 10:46 10
To Next Page
Loading...
Need help?
General
