Running Mail
82
3
Using the Feeder
The steps below describe how to place a stack of mail on the feed hopper.
In each stack, you may mix envelopes of different size, thickness and flap formats
(nested or closed).
You may process certain types of envelopes in both landscape and portrait mode.
How to Use the Feeder
How to Use the
Feeder
Taking a stack of mail:
1 Arrange the mail according to their size (largest and heaviest
on the bottom).
2 Fan the envelopes to ensure separation (sometimes en-
velopes may be stuck together).
3 Bevel the edge of the stack.
4
Place the envelopes on
the hopper against the
rear wall and covering
the optical (clear)
sensor. Be sure that all
envelopes in the stack
are against the rear wall.
Ensure that all the en-
velopes are stacked
along the rear guide,
from largest to smallest.
5
Adjust the high stack
side guide. To adjust the
guide, push gently
against the envelopes,
but do not push it tightly
against the stack.
Nested envelope flaps: insert the flaps into the slot at the rear
guide of the envelope hopper.
Do not try to seal self-adhesive envelopes. Close them
before
feeding.
OMEGA1_US.book Page 82 Vendredi, 1. octobre 2010 10:46 10
To Next Page
Loading...
Need help?
General
