Trainee Guide TR-L2-M2000
Level 2 Maintenance Training - M2000 Dispensing Systems 2-2-103 P/N 73-0018-00 (Revision B)
Outline Sheet 2-14-1
Tooling Flow Controls
A. Introduction
When a part is conveyed into the system, a sensor detects its presence and indexes the
part. Stop pins are raised to stop the board transport. Clamp bars or lift tables raise to
hold the part in place. It may be necessary to adjust the tooling flow controls that
regulate the air pressure provided to the lift tables and clamp bars.
B. Enabling Objective
2.14 Identify the steps required to adjust the tooling flow controls.
C. Topic Outline
1. Introduction
2. Overview
 Lift Tables/Clamp Bars
 Stop Pins
 Tooling Flow Controls
3. Summary and Review
To Next Page
Loading...
Need help?
General