Trainee Guide TR-L2-M2000
Level 2 Maintenance Training – M2000 Dispensing Systems 3-2-48 P/N 73-0018-00 (Revision B)
Exercise Sheet 3-6-13
Reconnecting the DJ-2000
Tools Needed:
3-mm hex key
1. Place the bracket mount into the slot of the Z-head.
2. The top of the bracket mount should be approximately 2” down from the top of the
Z-head slot.
3. Place the DJ-2000 onto the valve bracket, and mount it onto the protruding dowel pins.
4. Insert two hex screws through the setscrew holes in the strip across the back of the DJ-
2000, and use the 3-mm hex key to tighten them into the valve bracket.
5. Connect the solenoid cable to the Valve 1 connector. The connector should snap into
place. Then turn the lock ring to secure the connector.
6. Connect the fork shaped RTD cable to the white RTD connector.
7. Connect the single-pronged heater cable into the small needle heater on the bulkhead.
8. Connect the black pneumatic hose from the DJ-2000 to the black pneumatic line
(bottom connector) on the left side of the dispense head bulkhead.
9. Connect the height sensor cable to the height sensor connector on the dispensing head
bulkhead.
To Next Page
Loading...
Need help?
General