Trainee Guide TR-L2-M2000
Level 2 Maintenance Training – M2000 Dispensing Systems 4-2-39 P/N 73-0018-00 (Revision B)
Outline Sheet 4-10-1
Needle Sensor Failure
A. Introduction
The Needle Sensor allows you to change needles and continue production without
reprogramming the dispensing system. It can automatically compensate for XYZ
changes in needle location due to a needle change or a bent needle, therefore
minimizing operator error and eliminating wasted time spent manually adjusting the
needle. The following section identifies some possible needle sensor problems and their
solutions.
B. Enabling Objective
4.10 Perform troubleshooting procedures for the Needle Sensor and correct a Tactile
Sensor Error.
C. Topic Outline
1. Introduction
2. Overview
Symptoms and Causes of Needle Sensor Failure
3. Summary and Review
To Next Page
Loading...
