Trainee Guide TR-L2-M2000
Level 2 Maintenance Training – M2000 Dispensing Systems 3-2-49 P/N 73-0018-00 (Revision B)
Outline Sheet 3-7-1
Cleaning and Replacing Fans and Vents
A. Introduction
There are two fans located on the floor underneath the modules in the rear of your
dispenser. The function of these fans is to regulate the internal temperature of the
dispenser and prevent the modules from over-heating. The fans and vents should be
cleaned and replaced as needed.
B. Enabling Objective
3.7 Perform the procedure to clean and replace fans and vents.
C. Topic Outline
1. Introduction
2. Overview
 Cleaning the Fans and Vents
3. Summary and Review
To Next Page
Loading...
Need help?
General