Trainee Guide TR-L2-M2000
Level 2 Maintenance Training – M2000 Dispensing Systems 5-2-5 P/N 73-0018-00 (Revision B)
Outline Sheet 5-2-1
Removing and Replacing the Conveyor Controller Module
A. Introduction
Occasionally a technician may find it necessary to replace the Conveyor Controller Module.
The following section describes in detail how to remove and replace the Conveyor
Controller Module. If your system is equipped with a dual lane conveyor, there will be
two Conveyor Controller Modules.
B. Enabling Objective
5.2 Identify steps required to remove and replace the Conveyor Controller Module.
C. Topic Outline
1. Introduction
2. Overview
Removing and Replacing the Conveyor Controller Module
3. Summary and Review
To Next Page
Loading...
