Trainee Guide TR-L2-M2000
Level 2 Maintenance Training – M2000 Dispensing Systems 1-2-35 P/N 73-0018-00 (Revision B)
Information Sheet 1-8-2
Safety Precautions (Continued)
D. System Protection Precautions
1. Always wear a grounding strap when operating the dispensing system.
2. Be especially careful when dispensing with caustic or conductive fluids.
 Take appropriate action to immediately clean up and contain any spills.
 If fluid gets into internal portions of the system, call 1-800-ASYMTEK (279-6835)
immediately.
3. Maintain a clean and orderly work area.
4. Follow all suggested system maintenance.
5. Immediately remove parts that have fallen into the dispensing system.
6. Immediately clean up any spilled fluids.
E. Additional Precautions for Service Personnel
1. Only qualified personnel should be permitted to perform maintenance and
troubleshooting procedures.
2. When performing service or maintenance work on the dispensing system in areas
marked with an Electrical Warning Label:
 Turn OFF the Main Power Circuit Breaker at the rear of the system.
 Disconnect the Main Power Cord.
 Lock the power cord in the Lockout/Tagout box.
3. Before troubleshooting the Pneumatic Module, turn the Main Air Regulator Off
(0 psi) or disconnect the Main Air Supply.
To Next Page
Loading...
Need help?
General