Trainee Guide TR-L2-M2000
Level 2 Maintenance Training – M2000 Dispensing Systems 4-2-69 P/N 73-0018-00 (Revision B)
Outline Sheet 4-16-1
PMAC Plot
A. Introduction
One of the diagnostic tools available is a built-in tool called PMAC Plot. PMAC Plot is used
to measure and gather position, velocity and acceleration profiles of the dispense head for
dispensing programs written in FmNT that are installed on Asymtek servo systems. By
analyzing this information, service personnel can determine if the equipment is
functioning properly, thereby narrowing the focus of the troubleshooting effort.
B. Enabling Objective
4.16 Demonstrate the ability to gather and interpret PMAC Plot data.
C. Topic Outline
1. Introduction
2. Overview
 PMAC Plot
 Gathering Data
 Plotting Data
 Saving and Printing Data
3. Summary and Review
To Next Page
Loading...
Need help?
General