Trainee Guide TR-L2-M2000
Level 2 Maintenance Training – M2000 Dispensing Systems 4-2-5 P/N 73-0018-00 (Revision B)
Outline Sheet 4-2-1
XYZ Axis Failure
A. Introduction
The dispense head moves to the left, right, back and front on the X/Y-Axis rods. The
dispense head moves up and down on the Z-axis rod. Axis failure can be attributed to a
variety of causes.
B. Enabling Objective
4.2 Identify necessary steps to isolate XYZ axis failure and perform appropriate
recovery procedures.
C. Topic Outline
1. Introduction
2. Overview
Symptoms and Causes of XYZ Axis Failure
3. Summary and Review
To Next Page
Loading...
