Install the Internal HBA Card and HBA Super Capacitor
2.
Using a No. 2 Philips screwdriver, remove the standard HBA bracket that
shipped with the replacement HBA card.
3.
Install the special fitted bracket that was removed in Step 4 in “Remove the
Internal HBA Card and HBA Super Capacitor” on page 170.
4.
Carefully guide the SAS cables and super capacitor cable that connect to the
disk backplane and the super capacitor through the left-side cable trough.
174 Oracle Server X7-2 Service Manual • October 2017
To Next Page
Loading...
